ABB SAM600-IO Protocol Manual page 103

1MRK 511 440-UEN A
Switchgear control unit SAM600-IO Version 2.2 IEC
Communication protocol manual
RCA
RISC
RMS value
RS422
RS485
RTC
RTU
SA
SBO
SC
SCL
SCS
SCADA
SCT
SDU
SELV circuit
SFP
SLM
SMA connector
SMT
SMS
SNTP
SOF
SPA
SRY
ST
Relay characteristic angle
Reduced instruction set computer
Root mean square value
A balanced serial interface for the transmission of digital
data in point-to-point connections
Serial link according to EIA standard RS485
Real-time clock
Remote terminal unit
Substation Automation
Select-before-operate
Switch or push button to close
Short circuit location
Station control system
Supervision, control and data acquisition
System configuration tool according to standard IEC
61850
Service data unit
Safety Extra-Low Voltage circuit type according to
IEC60255-27
Small form-factor pluggable (abbreviation)
Optical Ethernet port (explanation)
Serial communication module.
Subminiature version A, A threaded connector with
constant impedance.
Signal matrix tool within PCM600
Station monitoring system
Simple network time protocol – is used to synchronize
computer clocks on local area networks. This reduces the
requirement to have accurate hardware clocks in every
embedded system in a network. Each embedded node can
instead synchronize with a remote clock, providing the
required accuracy.
Status of fault
Strömberg Protection Acquisition (SPA), a serial master/
slave protocol for point-to-point and ring communication.
Switch for CB ready condition
Switch or push button to trip
Section 10
Glossary
97