Document Conventions; Iec 61850 Edition 1 / Edition 2 Mapping - ABB SAM600-IO Protocol Manual

1MRK 511 440-UEN A
1.4.2
1.5
Switchgear control unit SAM600-IO Version 2.2 IEC
Communication protocol manual

Document conventions

• Abbreviations and acronyms in this manual are spelled out in the glossary. The
glossary also contains definitions of important terms.
• Parameter names are shown in italics.
For example, the function can be enabled and disabled with the Operation
setting.
• Each function block symbol shows the available input/output signal.
• the character ^ in front of an input/output signal name indicates that the
signal name may be customized using the PCM600 software.
• the character * after an input signal name indicates that the signal must
be connected to another function block in the application configuration
to achieve a valid application configuration.
• Logic diagrams describe the signal logic inside the function block and are
bordered by dashed lines.
• Signals in frames with a shaded area on their right hand side represent
setting parameter signals that are only settable via the PST, ECT.
Illustrations are used as an example and might show other products
than the one the manual describes. The example that is illustrated is
still valid.

IEC 61850 edition 1 / edition 2 mapping

Function block names are used in ACT and PST to identify functions. Respective
function block names of Edition 1 logical nodes and Edition 2 logical nodes are
shown in the table below.
Table 1: IEC 61850 edition 1 / edition 2 mapping
Function block name
AGSAL
ALMCALH
ALTIM
ALTMS
ALTRK
BTIGAPC
DPGAPC
DRPRDRE
INDCALH
ITBGAPC
Table continues on next page
Edition 1 logical nodes
AGSAL
SECLLN0
ALMCALH
-
-
-
B16IFCVI
DPGGIO
DRPRDRE
INDCALH
IB16FCVB
Section 1
Introduction
GUID-96DFAB1A-98FE-4B26-8E90-F7CEB14B1AB6 v7
GUID-C5133366-7260-4C47-A975-7DBAB3A33A96 v5
Edition 2 logical nodes
AGSAL
ALMCALH
ALTIM
ALTMS
ALTRK
BTIGAPC
DPGAPC
DRPRDRE
INDCALH
ITBGAPC
9