Document Conventions; Iec 61850 Edition 1 / Edition 2 Mapping - ABB Relion SAM600 Applications Manual

Section 1
Introduction
Although warning hazards are related to personal injury, it is necessary to understand that
under certain operational conditions, operation of damaged equipment may result in
degraded process performance leading to personal injury or death. It is important that the
user fully complies with all warning and cautionary notices.
1.4.2

Document conventions

• Abbreviations and acronyms in this manual are spelled out in the glossary. The glossary
also contains definitions of important terms.
• Parameter names are shown in italics.
For example, the function can be enabled and disabled with the
• Each function block symbol shows the available input/output signal.
•
•
• Dimensions are provided both in inches and millimeters. If it is not specifically mentioned
then the dimension is in millimeters.
1.5

IEC 61850 edition 1 / edition 2 mapping

Function block names are used in ACT and PST to identify functions. Respective function block
names of Edition 1 logical nodes and Edition 2 logical nodes are shown in the table below.
Table 1:
Function block name
AGSAL
ALMCALH
ALTIM
ALTMS
ALTRK
BTIGAPC
DPGAPC
DRPRDRE
INDCALH
ITBGAPC
L4UFCNT
LD0LLN0
LPHD
MVGAPC
QCBAY
RCHLCCH
SCHLCCH
SCSWI
SLGAPC
Table continues on next page
10
the character ^ in front of an input/output signal name indicates that the signal
name may be customized using the PCM600 software.
the character * after an input signal name indicates that the signal must be
connected to another function block in the application configuration to achieve a
valid application configuration.
IEC 61850 edition 1 / edition 2 mapping
Edition 1 logical nodes
© Copyright 2017 ABB. All rights reserved
AGSAL
SECLLN0
ALMCALH
-
-
-
B16IFCVI
DPGGIO
DRPRDRE
INDCALH
IB16FCVB
L4UFCNT
LLN0
LPHD
MVGGIO
QCBAY
RCHLCCH
SCHLCCH
SCSWI
SLGGIO
1MRK 511 445-UEN B
GUID-96DFAB1A-98FE-4B26-8E90-F7CEB14B1AB6 v8
Operation setting.
GUID-C5133366-7260-4C47-A975-7DBAB3A33A96 v7
Edition 2 logical nodes
AGSAL
ALMCALH
ALTIM
ALTMS
ALTRK
BTIGAPC
DPGAPC
DRPRDRE
INDCALH
ITBGAPC
L4UFCNT
-
MVGAPC
BAY/LLN0
RCHLCCH
SCHLCCH
SCSWI
SLGAPC
Switchgear control unit SAM600-IO
Application manual