NEC Express5800 Series User Manual page 105

Chapter 3 Setup
4. POST displays several types of message. These messages let you know that the installed CPU or
connected keyboard and mouse are detected.
5. After a while, the following message is displayed on the screen.
Press <F2> SETUP, <F3> Internal Flash Memory, <F4> ROM Utility, <F12> Network
You can call the functions below upon completion of POST by pressing the designated function key.
<F2> key:
<F3> key:
<F4> key:
<F12> key: Boot from network.
6. When the boot mode is legacy BIOS and a controller which has the dedicated BIOS is installed, a
message that prompts you to start the utility is displayed.
Example: optional RAID controller
Press <Ctrl> <R> to Run MegaRAID
Configuration Utility
The utility starts by pressing <Ctrl> + <R> keys.
Example: on-board RAID controller
Press <Ctrl> <M> to Run LSI Software RAID Configuration Utility
The utility starts by pressing <Ctrl> + <M> keys.
For details on the utility, refer to the manual supplied with each optional board.
Depending on the hardware configuration, the message "Press Any Key" might appear to prompt a
key entry. This is a behavior of the BIOS of the optional board. Continue to operate after checking the
manual of the optional board.
7. If you set a password at SETUP in the BIOS Setup utility, the password entry appears upon successful
completion of POST.
Up to three password entries will be accepted. Three incorrect password entries disable the server to
boot. In such a case, turn off the power and wait about ten seconds before turning on to boot the server.
Tips
The value of memory capacity shown in the message may be smaller than the
actual physical memory depending on the hardware configuration. This applies to
the information in SETUP and system information of the operating system.
Tips When Server  Power Measurement Policy is One time or Always, the power
measurement message appears instead of the above message. Wait until the
measurement is complete.
Run the SETUP. For information on the SETUP, see Chapter 3 (2. System BIOS Setup).
Run EXPRESSBUILDER
EXPRESSBUILDER, see Chapter 3 (4. EXPRESSBUILDER).
Note
If bootable CD/DVD is inserted into optical disk drive, the system starts from
CD/DVD even if <F3> key is pressed.
Run the offline tool. For information on the offline tool, see Chapter 1 Maintenance (9.
Offline Tools) in "Maintenance Guide".
Important
Do not set a password before OS is installed.
Express5800/T110i User's Guide
from Internal Flash Memory.
1. Turning on the Server
For information on
105