NEC Express5800 Series User Manual page 113
Hide thumbs
Also See for Express5800 Series:
- User manual (574 pages) ,
- Maintenance manual (238 pages) ,
- Installation manual (75 pages)
Table of Contents
Advertisement
Chapter 3 Setup
On Off-line TOOL MENU, select Server Configuration Utility EXPRESSSCOPE Engine 3
4.
Configuration Network IPv4 Property or IPv6 Property.
5.
On the following screen, select Enable when you use DHCP, or select Disable and specify IP
Address (Required), Subnet Mask (Required), Default Gateway, and DNS Server when you do not
use DHCP.
6.
Connect the LAN cable to the management LAN connector in order to connect to the network. It will
be available for use if you access EXPRESSSCOPE Engine 3 via Web browser from management
PC according to the setting.
Tips
If Shared BMC LAN is enabled, Web feature, remote media/KVM feature, or command
line interface feature may be interrupted. In this case, wait for a while, and connect with
network again.
When IPv4 Property is selected
Express5800/T110i User's Guide
3. EXPRESSSCOPE ENGINE 3
113
Advertisement
Table of Contents
