NEC Express5800 Series User Manual page 28

Chapter 1 General Description
STATUS LED 1, 2 pattern
STATUS LED 1 STATUS LED 2
On (green) Off
On (green) On (amber)
Blinking (green) Off
Off Off
Off On (amber)
Off Blinking (amber) Power Supply Unit is failing (in power
28
Description
The server is operating normally.
Initialization of BMC is in progress.
Memory is in a degraded state
A correctable memory error has often
occurred.
Operating while CPU error is detected.
In redundant power configuration, power is
not supplied to either of power unit.
The power is off.
POST is in progress.
Watchdog timer expired.
Memory dump is being requested.
Note: The LED remains green if the dump is
caused by software.
A temperature alarm was detected.
A CPU error occurred.
A PCI system error occurred
A PCI parity error occurred
A PCI bus error occurred.
A voltage alarm was detected.
Sensor error was detected.
A CPU temperature alarm was detected.
An error occurred on Intel Node Manager
(one of the features of EXPRESSSCOPE
Engine 3).
redundant configuration).
A fan alarm was detected.
A temperature warning was detected.
A voltage warning was detected
One or more hard disk drives are failing
(Only when a RAID system configuration
was built hot-plug HDD).
Express5800/T110i User's Guide
4. Names and Functions of Parts
Action
–
Wait until initialization completes.
Find the device in degraded state by using
BIOS Setup Utility (SETUP), and replace it as
soon as possible.
Turn on the server.
Wait for a while. STATUS LED will turn green
after POST completes.
Turn off the power and then turn it on.
If POST displays any error message, take
notes of the message, and contact your sales
representative.
Wait until the memory dump is completed.
Check the internal fan for dusts. Also check if
the fan unit is properly connected.
Turn off the power and then turn it on.
If POST displays any error message, take
notes of the message, and contact your sales
representative.
Contact your sales representative.
Contact your sales representative.
Check if the internal fan cable is properly
connected.
Check the internal fan for dusts. Also check if
the fan unit is properly connected.
Contact your sales representative.