Table of Contents
Advertisement
8.2.10
Firmware Update
The IP gateway has the option to manually update the device software.
Note
■
■
■
Perform the following steps to update your device, if necessary.
1. Get the latest software from your electrical installer.
2. Log into the Web-Interface of the IP-Gateway with the username "admin" and the
associated password.
3. Open menu item firmware update and upload the .tar/.img file.
4. After the file has been sent to the IP-Gateway and installed on the device, the IP-Gateway is
reachable again via the browser.
ATTENTION: This process may take up to 10 minutes. The device must not be disconnected
from the power supply during this period.
5. Afterwards, the IP-Gateway can be taken into use again.
The user name and password have been reset to the factory settings admin / admin .Assign a
new password if necessary.
Re-enter the configuration data (basic settings, device settings). Set the time zone.
Note
In case of a fixed IP address there is the possibility that the device has obtained
a new address via DHCP after the software update.
Product manual 2TMD041600D0041
Device updates are not normally required and should only be carried out for
troubleshooting purposes. To update the device, please contact your electrical
installer.
Before updating the firmware, always check if the update bears a date more recent
that the software already installed. See also the section "Version information".
All settings of the IP gateway will been reset to the factory settings during the update.
Please first note down the details specified under basic settings and device settings.
Commissioning
│41
Advertisement
Table of Contents
