Table of Contents
Advertisement
WV-X8570N / WV-S8530N
Model No.
* For information about the installation tasks, refer to the provided Installation
Guide. For information about how to perform the settings and how to
operate the camera, refer to the Operating Instructions on the following
Panasonic support web site.
https://security.panasonic.com/download/
please read these instructions carefully and save this manual for future use.
The model number is abbreviated in some descriptions in this manual.
Important Information
WV-X8570N
Before attempting to connect or operate this product,
Network Camera
Advertisement
Table of Contents
Related Manuals for Panasonic WV-X8570N
Summary of Contents for Panasonic WV-X8570N
- Page 1 Important Information Network Camera WV-X8570N / WV-S8530N Model No. WV-X8570N * For information about the installation tasks, refer to the provided Installation Guide. For information about how to perform the settings and how to operate the camera, refer to the Operating Instructions on the following Panasonic support web site.
-
Page 2: Table Of Contents
Contents Limitation of liability ........................3 Disclaimer of warranty ........................3 Preface ............................4 About notations ..........................4 Main functions ..........................4 About the user manuals ........................ 6 System requirements for a PC ...................... 6 Trademarks and registered trademarks..................7 Copyright ............................ -
Page 3: Limitation Of Liability
IMPROVEMENTS OF THIS PUBLICATION AND/OR THE CORRESPONDING PRODUCT (S). Disclaimer of warranty IN NO EVENT SHALL Panasonic Corporation BE LIABLE TO ANY PARTY OR ANY PERSON, EXCEPT FOR REPLACEMENT OR REASONABLE MAINTENANCE OF THE PRODUCT, FOR THE CASES, INCLUDING BUT NOT LIMITED TO BELOW:... -
Page 4: Preface
The following notations are used when describing the functions limited for specified models. The functions without the notations are supported by all models. X 8570 The functions with this notation are available when using the model WV-X8570N. S 8530 The functions with this notation are available when using the model WV-S8530N. - Page 5 Achieves high-level shock resistance with IK10 (IEC 62262) conformity. The camera has a strong shock resistance body which is needed in outdoor installations. Encryption and alteration detection functions enhanced the security. *1 A technology to significantly reduce a band by increasing the compression ratio of areas where a subject does not move and optimizing the refresh interval and frame rate according to subject motions.
-
Page 6: About The User Manuals
Precautions for installation, Parts and functions, etc.. • Installation Guide: Explains installation, mounting, cable connections, and adjusting the field of view. • Operating Instructions (on the Panasonic support web site): Explains how to perform the settings and how to operate this camera. Note: •... -
Page 7: Trademarks And Registered Trademarks
IMPORTANT: • For information on the operation verification of the supported operating systems and web browsers, refer to our website at https://security.panasonic.com/support/info/. <Control No.:C0104> • When using a PC that does not meet the above requirements, displaying of images may become slower or the web browser may become inoperable. -
Page 8: Open Source Software
• Refer to the “readme.txt” file on the provided CD-ROM for further information about open source software licenses and the source code. • Please note that Panasonic shall not respond to any inquiries regarding the contents of the source code. -
Page 9: Precautions
Precautions Do not insert any foreign objects. Do not attempt to disassemble or modify Fire or electrical shock may be caused if water this product. or any foreign objects, such as metal objects, Failure to observe this may cause fire or electric enter inside the unit. - Page 10 Install this product in a location high Refer to the Operating Instructions on the enough to avoid people and objects from Panasonic support web site for information bumping the product. about how to change passwords. Failure to observe this may cause injury.
- Page 11 About the automatic status detection We shall not be liable for content function compensation, losses of recorded or When this product malfunctions due to exoge- edited content and any direct or indirect nous noise, etc. for 30 seconds or more, the consequent damages caused by failure to product will automatically reset and will return record or edit due to faults with this unit or...
- Page 12 Cleaning of the dome cover OBTAINED FROM A VIDEO PROVIDER When cleaning the dome cover, hose or LICENSED TO PROVIDE AVC VIDEO. NO spray fresh water that is not containing LICENSE IS GRANTED OR SHALL BE lubricant agent or silicon substances and IMPLIED FOR ANY OTHER USE.
-
Page 13: Precautions For Installation
Precautions for installation Panasonic assumes no responsibility for injuries or property damage resulting from failures arising out of improper installation or operation inconsistent with this documentation. For information about the installation tasks, refer to the provided Installation Guide. In order to prevent injury, the product •... - Page 14 Refer to the Operating Instructions on the cause reflection of infrared rays resulting in a Panasonic support web site for further informa- part of the screen or the entire screen tion about the port forwarding function.
-
Page 15: Parts And Functions
【Whole unit】 Base bracket Conduit wiring (accessory) connector Attachment plate (accessory) Safety wire Fixing screws for attachment plate (accessory) On the Panasonic Camera body logo side Camera 2 Installed auxiliary wire Two-dimensional barcode (Data Matrix) Inside To our website* Dome... - Page 16 【Camera body】 * This illustration represents WV-S8530N Camera 4 USB terminal (for installation constructor) Camera 3 Camera 1 SD slot Auxiliary handle (accessory) S 8530 Camera 2 Camera fixing screw ⇩ On the Panasonic logo side...
- Page 17 Off, input, and output of the external I/O terminal 2 and 3 can be switched by configuring the setting. Refer to the Operating Instructions on the Panasonic support web site for further infor- mation about the external I/O terminal 2 and 3 (ALARM IN2, 3) settings ("Off", "Alarm input", "Alarm output"...
- Page 18 4P alarm cable GND (Black) ALARM IN3 (Alarm input 3/ Alarm output/ AUX output) (Gray) ALARM IN2 (Alarm input 2/ Alarm output) (Red) ALARM IN1 (Alarm input 1/ Black & white input/ Auto time adjustment input) (Green) IMPORTANT: Install external devices so that they do not exceed the rating of the network camera. ...
- Page 19 When connecting to a network using a PoE hub Before starting the installation, check the entire system configuration. The following illustration gives a wiring example of how to connect the camera to the network via a PoE device (hub). PoE device (hub) Ethernet cable Ethernet cable (category 5e or better,...
- Page 20 ■ Indicators and buttons * Image of camera 1 is omitted for simple explanation. SD slot SD ON/OFF button INITIAL SET button SD MOUNT indicator ESD ERROR indicator ACT indicator LINK indicator INITIAL SET button Follow the steps below to initialize the network camera. ⑴...
- Page 21 Lighting/blinking LED can be turned off with the software settings at any time. (The initial state is lighting or blinking.) Set the LED to be solid off if necessary, depending on the installation condi- tions. (☞ Operating instructions on the Panasonic support web site)
-
Page 22: Insert/Remove An Sd Memory Card
Insert / remove an SD memory card Note: Refer to the Operating Instructions on the Panasonic support web site for further information about the SD memory card settings. ■ Insert an SD memory card 【１】 Remove the dome cover from the camera, insert an SD memory card fully into the SD slot until a click is heard. - Page 23 If an unformatted SD memory card or an SD memory card formatted with other devices is used, this product may not work properly or performance deteri- oration may be caused. Refer to the operating instructions on the Panasonic support web site for how to format an SD memory card.
-
Page 24: Configure The Network Settings
CDLauncher 【2】 Click the [Run] button next to [IP Setting Software]. ⇒ [Panasonic IP Setting] screen will be displayed. The MAC Address / IP address of the detected camera will be displayed. 【3】 Select the camera you want to configure (A), and click [Network Settings] (B) to change the network settings. - Page 25 Enter the registered user name and password. The default setting of user authentication is “On”. For further information, refer to the “Preface” section in the Operating Instructions on the Panasonic support web site. IMPORTANT: ...
-
Page 26: Troubleshooting
Use an SD memory card formatted on the camera. lights red Or install the software to format the SD memory card on the PC. Refer to our website (https://security.panasonic.com/support/info/ <Control No.:C0105>)) for further information about the supported software. • Isn't the inserted SD memory card faulty? - Page 27 Reference Symptom Cause/solution pages • Check the following. • Grounding of the camera, a switching hub or peripheral devices are not done. • The camera is used near an electrical power line. • The camera is used near a device which produces Audio input contains strong magnetic field or radio waves (such as near a TV/radio antenna, a motor of an air conditioning...
-
Page 28: Specifications
Specifications Basic • Power source * PoE (IEEE802.3af compliant) Power consumption * X 8570 PoE DC 48 V : 265 mA/Approx. 12.95 W (Class 0 device) S 8530 PoE DC 48 V : 210 mA/Approx. 10.1 W (Class 0 device) Operating environment Ambient operating temperature: –40 °C to +60 °C {–40 °F to +140 °F}... - Page 29 *1 Refer to our website (https://security.panasonic.com/support/info/ <Control No.:C0106>) for further information about Power source and Power consumption information. *2 Only when installation work is properly performed according to the Installation Guide and appropriate waterproof treatment is performed. *3 Component that has a structure on which the screws that are accessible after installation can- not be screwed or unscrewed using an ordinary screwdriver.
- Page 30 Maximum shutter: Max.1/10000s, Max.1/4000s, Max.1/2000s, Max.1/1000s, Max.1/500s, Max.1/250s, Max.1/120s, Max.1/100s, Max.2/120s, Max.2/100s, Max.3/120s, Max.1/30s, Max.2/30s, Max.4/30s, Max.6/30s, Max.10/30s, Max.16/30s Color/BW: Off/ On/ Auto1(Normal)/ Auto2(IR Light)/ Auto3(SCC) White balance: ATW1/ ATW2/ AWC Digital noise reduction: The level can be set in the range of 0 to 255. Privacy zone: On/ Off (up to 8 zones available) Camera title on screen:...
- Page 31 Angular field of view: X 8570 [16:9 mode*] *Cannot be changed. Horizontal: 97 ° / Vertical: 53 ° S 8530 [16:9 mode] Horizontal : 53 ° (TELE) – 99 ° (WIDE) Vertical : 30 ° (TELE) – 54 ° (WIDE) [4:3 mode] Horizontal : 44 °...
- Page 32 * Depends on network conditions Compatible SDXC/SDHC/SD Manufactured by Panasonic (SD speed class 4 or higher) memory card* SDXC memory card : 64 GB, 128 GB, 256 GB SDHC memory card : 4 GB, 8 GB, 16 GB, 32 GB...
- Page 33 Microsoft Windows or Windows Internet Explorer, click “Manual” - “Open” from the supplied CD-ROM and refer to “Notes on Windows / Internet Explorer versions”. *5 Refer to our website (https://security.panasonic.com/support/info/ <Control No.:C0107>) for latest information about the compatible SD memory cards.
-
Page 34: Optional Accessories
Optional accessories Ceiling mount bracket : WV-Q105A* <Light gray brackets> Wall mount bracket: WV-Q185* Mount bracket: WV-Q187* Pole Mount Bracket: WV-Q182* Corner Mount Bracket: WV-Q183* <Fine silver brackets> Wall mount bracket: WV-Q122A* Pole Mount Bracket: WV-Q188* Corner Mount Bracket: WV-Q189* *1 This product can only be installed indoors when WV-Q105A is used to install it on the ceiling. - Page 35 For U.S. and Canada: For Europe and other countries: Panasonic Corporation of North America Panasonic Corporation Two Riverfront Plaza, Newark, NJ 07102-5490 http://www.panasonic.com http://business.panasonic.com/ Panasonic Canada Inc. Panasonic Corporation Osaka, Japan 5770 Ambler Drive, Mississauga, Ontario, L4W 2T3 Canada 1-877-495-0580 Authorised Representative in EU: https://www.panasonic.com/ca/...