Page 1
"<Control No.: C****>" used in these documents should be used to search for information on our support website (https://security.panasonic.com/training_support/support/info/) and will guide you to the right information. • SDXC/ SDHC/ SD memory card is described as SD memory card.
Contents Limitation of liability ........................3 Disclaimer of warranty ........................3 About notations ..........................4 System requirements for a PC ...................... 4 Network security ........................... 5 Precautions for use ........................6 Parts and functions ........................9 Troubleshooting ........................... 12 Detail specifications ........................14...
IMPROVEMENTS OF THIS PUBLICATION AND/OR THE CORRESPONDING PRODUCT (S). Disclaimer of warranty IN NO EVENT SHALL Panasonic i-PRO Sensing Solutions Co., Ltd. BE LIABLE TO ANY PARTY OR ANY PERSON, EXCEPT FOR REPLACEMENT OR REASONABLE MAINTENANCE OF THE PRODUCT, FOR THE CASES, INCLUDING BUT NOT LIMITED TO BELOW:...
The following notations are used when describing the functions limited for specified models. The functions without the notations are supported by all models. X4573L The functions with this notation are available when using the model WV-X4573L. X4573LM The functions with this notation are available when using the model WV-X4573LM.
Network security As you will use this unit connected to a network, your attention is called to the following security risks. A Leakage or theft of information through this unit B Use of this unit for illegal operations by persons with malicious intent C Interference with or stoppage of this unit by persons with malicious intent It is your responsibility to take precautions such as those described below to protect yourself against the above network security risks.
Precautions for use When the product is accessible from the Periodically images on the screen appear to Internet be distorted To prevent unauthorized access, note the following. When the camera is installed in a location where • Leave user authentication turned on. it is subject to small vibrations (for example, when •...
Page 7
What to do if “WARMING UP-PLEASE WAIT” Cleaning of the dome cover appears on the display. Use lens cleaning paper (used to clean camera This message indicates that the temperature or spectacles lenses) to remove any dirt on the inside the camera has become extremely low. dome cover.
Page 8
Router When connecting this product to the Internet, use a broadband router with the port forwarding function (NAT, IP masquerade). Refer to the Operating Instructions for further information about the port forwarding function. Time & date setting It is necessary to set the time & date before putting this product into operation.
Parts and functions Cables Pin No. Signal Name Wire Color TXD+ White·Green RXD+ White·Orange M12 connector TXD- Green RXD- Orange X4573LM S4551LM Female Male {1} M12 Network cable X4573L S4551L Ethernet cable (category 5e or better, straight, 4 pairs (8 pins)) {1} RJ45 Network cable {3} EXT I/O cable {3} 4P alarm cable (accessory)
Page 10
{2} Power supply cable / 2P power cable (accessory) Connect the output cable of the AC adaptor to the 2P power cable (accessory) and then connect the 2P power cable to the power connection cable. IMPORTANT: • Be sure to use the 2P power cable (accessory) provided with this product. •...
Page 11
{4} Audio input cable (white) Connect a microphone or the line out of an external device using a stereo mini plug (ø3.5 mm). <For microphone input> • Recommended microphone: Plug-in power type (locally procured) (Sensitivity of microphone: –48 dB ±3 dB (0 dB=1 V/Pa,1 kHz)) •...
Troubleshooting Before asking for repairs, check the symptoms with the following table. Contact your dealer if a problem cannot be solved even after checking and trying the solution in the table or a problem is not described below. Reference Symptom Cause/solution pages When using a PoE device for power supply...
Page 13
Reference Symptom Cause/solution pages • Check the following. • Grounding of the camera, a switching hub or periph- eral devices are not done. • The camera is used near an electrical power line. • The camera is used near a device which produces Audio input contains Installation strong magnetic field or radio waves (such as near a...
Detail specifications Basic • Power source * DC 12 V PoE (IEEE802.3af compliant) X4573L S4551L PoE (IEEE802.3af compliant) (Alternative A) X4573LM S4551LM Power consumption * X4573L X4573LM DC 12 V: 1.04 A/ Approx. 12.5 W PoE DC 48 V : 260 mA/ Approx. 12.5 W (Class 0 device) S4551L S4551LM DC 12 V:...
Page 15
When using base bracket : Mass: Approx. 1.3 kg {2.87 lbs.} When using attachment plate only : Approx. 880 g {1.94 lbs} X4573L X4573LM Approx. 870 g {1.92 lbs} S4551L S4551LM Finish: Main body: Aluminum die cast, i-PRO white Outer fixing screws : Stainless steel (Corrosion-resistant treatment) Dome cover: Polycarbonate resin, Clear Others :...
Page 16
Minimum illumination: X4573L X4573LM Color : 0.3 lx {0.0279 footcandle} (50IRE, F1.9, Maximum shutter: Off (1/30 s), AGC: 11) 0.02 lx {0.0019 footcandle} (50IRE, F1.9, Maximum shutter: max. 16/30 s, AGC: 11)* : 0 lx {0 footcandle} (50IRE, F1.9, Maximum shutter: Off (1/30 s), AGC: 11, when the IR LED is lit)) 0.04 lx {0.0037 footcandle} (50IRE, F1.9, Maximum shutter: Off (1/30 s), AGC: 11)