HP 81101A Quick Start Manual page 29

2
2Getting Started
The intention of this chapter is to give the necessary steps to set up
generic signals for first-time users of the HP 81101A.
This chapter provides examples for the following types of signals:
•
•
•
At the end of each example, the required set of device commands is listed
to provide programming examples. For further information on the
commands and a complete command reference please refer to the
Reference Guide, p/n 81101-91011.
The examples are intended to be performed one after the other.
Therefore, the first example provides the most detailed instructions,
while the other examples are described on a higher level.
"Setting Up a Clock Signal" on page 30
"Setting Up a Pulse Signal" on page 35
"Setting Up a Burst Signal" on page 39
29