Siemens SINAUT MD740-1 User Manual page 64

Configuration
Access # # # # HTTPS
64 von 105
When HTTPS remote access is switched on, the
SINAUT MD740-1 can be configured via its web-based
administrator interface from a remote computer. This means that
the browser on the remote computer is used to configure the local
SINAUT MD740-1.
This option is switched off as default.
!
N.B.:
When you enable remote access, make sure that a secure root
and administrator password have been determined.
To enable HTTPS remote access, make the following settings:
Enable HTTPS remote access: Yes / No
If you want to enable HTTPS remote access, set this switch to
Yes.
!
In this case, make sure that the firewall rules on this page
are set so that the SINAUT MD740-1 can be accessed from
the outside.
!
If you set this parameter to No by remote access, no further
entries by HTTPS remote access are possible. This option
must then be accepted again, either locally or by SSH
remote access, provided that this has been configured.
Port for incoming HTTPS connections (remote
administration only)
Default: 443
You can determine a different port.
!
If you have determined a different port, the remote site
which makes the remote access must then give the port
number after the IP address in the address information.
Example:
If this SINAUT MD740-1 can be reached via the Internet
using the address 192.144.112.5, and if the port number
442 has been determined for remote access, then the
SINAUT MD740-1