Installation Method - Mitsubishi Electric A960GOT User Manual

6 HANDLING

6.1.2 Installation method

6 - 3
This section provides how to install the GOT.
(1) Mounting panel cutting dimensions
When mounting the GOT on a control box door, user-made mounting base or the
like, the door or mounting base must be cut as indicated below.
A
Panel opening
(2) Mounting position
When mounting the GOT, the following clearances must be left from the other
device.
D
(100mm
(3.94inch)
or more)
Plate thicness
within 2 to 4mm (0.08 to 0.16inch)
Part A size: Because the connection cable of the GOT is pulled downward, the
following space is required according to its radius of curvature.
A97 GOT+Communication board
A985GOT(-V)/A960GOT+Communication board
A97 GOT+A9GT-BUSSU/BUS2SU
A985GOT(-V)/A960GOT+A9GT-BUSSU/BUS2SU
When using a cable prepared by user, please consider the
connector cover to be used and the bending radius of the cable.
When using a bar code reader, please consider the dimensions of
the connector to be used and the bending radius of the cable.
Part B size:
When using a PC card or an speech output device (for a connected cable
connector and a wire), a clearance of 100mm (3.94inch) or more is required.
When removing a PC card by opening a cover of the memory card interface
part, a clearance of 50mm (1.97inch) is required.
(A clearance of 50mm (1.97inch) or more is required when an audio speech
device or a memory card is not used.)
Part C size: Please allow a gap 80mm (3.15inch) or more from the structure and
other equipment in the upper part of the unit to often allow good
ventilation.
Part D size: When installing devices that generate radiated noise (such as a
contactor) or a device that generate heat near the GOT, always
leave a clearance of 100mm (3.94inch) or more to the back and
50mm (1.97inch) or more to the left and right to avoid the effects of
the noise and heat.
Type
A985GOT(-V)
A975GOT
A970GOT
A960GOT
(80mm(3.15inch)
C
or more)
B
Other
(50mm
device
(1.97inch)
A
or more)
Type
MELSEC-GOT
A [mm] (inch) B [mm] (inch)
302 (11.89)
[+1.0 (0.04), -0 (0)] [+1.0 (0.04), -0 (0)]
289 (11.39)
[+1.0 (0.04), -0 (0)] [+1.0 (0.04), -0 (0)]
258 (10.17)
[+1.0 (0.04), -0 (0)] [+1.0 (0.04), -0 (0)]
B
(50mm
(1.97inch)
or more)
A [mm] (inch)
130 (5.12) or more
140 (5.51) or more
15 (0.59) or more
30 (1.18) or more
228 (8.98)
200 (7.88)
183 (7.21)
6 - 3