Cleaning The Base Unit; Cleaning In The Dishwasher; Cleaning The Accessories; Cleaning, Checking And Replacing Seals - Silvercrest MONSIEUR CUISINE PLUS SKMK 1200 A1 Operating Instructions Manual

BB&3(B)5ERRN 6HLWH  )UHLWDJ  -XQL   
CAUTION:
~ Never use any abrasive, corrosive or
scratching cleaning agents. These might
damage the device.
NOTE:
• Certain food or spices (e.g. curry) may
discolour plastic. This is not a defect
with the device and harmless to health.

15.1 Cleaning the base unit

1. Clean the outside of the base unit|12
with a damp cloth. You can also use
some detergent.
2. Use clear water and wipe with a clean
cloth.
3. Do not use the base unit|12 until it is
completely dry again.
15.2 Cleaning in the dish-
washer
The following parts are dishwasher-safe:
- Blender jug|5
- Measuring beaker|33
- Lid for blender jug|32
- Seal for the lid of the blender jug|31
- Blade assembly|27
- Seal for blade assembly|26
- Cooking pot|28
- Mixer attachment|29
- Spatula|30
- Steamer basket, deep|3
- Seal of the deep steamer basket|4
- Steamer basket, shallow|2
- Lid for the steamer baskets|1
Never use a dishwasher to clean the fol-
lowing parts:
- Base unit|12

15.3 Cleaning the accessories

1. Rinse the blender jug|5 with warm wa-
ter and dump the water.
2. Remove the blade assembly|27 (see
"Using and removing the blade assem-
bly" on page 52) and take the seal|26
off (see "Cleaning, checking and re-
placing seals" on page 61).
3. Clean all accessories by hand in a sink
with dishwater or in the dishwasher.
4. When cleaning by hand, rinse all parts
with clean water.
5. Allow the parts to dry completely before
using them again.
6. Before using the device again, reinsert
the blade assembly|27.
15.4 Cleaning, checking and
replacing seals
Remove seals|26,|31 and|4 for cleaning
and check them for damage. Pay attention
to changes (e.g. porous material or tears).
- The removed seals|26,|31 and|4 can
be cleaned in the dishwasher.
- Damaged seals|26,|31 and|4 must be
replaced with new ones. You can reor-
der new seals (see "How to order acces-
sories" on page 65).
CAUTION:
~ Prior to the next use, damaged
seals|26,|31 and|4 must be inserted
again or replaced with new ones. An
operation without seals|26,|31 and|4
in place is not permitted.
Blade assembly
|27
1. Remove the blade assembly|27 from
the blender jug|5 (see "Using and re-
moving the blade assembly" on
page 52).
2. Pull seal|26 off the blade assembly|27.
61
GB