Application Mode "Mobile; Acquire Data And Transfer It To Rf-Manager - Siemens SIMATIC RF310M Operating Instructions Manual

RF-MANAGER RF310M software

9.3 Application mode "Mobile"

Transfer data to RF-MANAGER
All acquired data is transferred immediately to RF-MANAGER. The Note symbol disappears
following the transfer.
9.3 Application mode "Mobile"
In application mode "Mobile" that is configured via the Engineering System in RF-
-MANAGER, you can check the scanned data for validity in the SIMATIC RF310M mobile
handheld terminal and reject any faulty data. Only that data which you have acknowledged
will be transferred to RF-MANAGER.
Functional expansion by means of configuration in the Engineering System
When the function "Edit Tag" is activated in RF-MANAGER, you can display and edit all the
data for the read RFID tag. However, changes in the data editor are not transferred directly
to the RF-MANAGER. See Acquire data and transfer it to RF-MANAGER (Page 64).
9.3.1

Acquire data and transfer it to RF-MANAGER

Data acquisition
Depending on the configuration in the Engineering System, you can activate an RFID read
operation using the hardware keys, the RF-MANAGER, or the "Scan" button of SIMATIC
RF310M.
If you have configured the reading of RFID tag data, the scanned tag ID will be preceded by
"RFID".
Figure 9-3
64
List of RFID tag IDs.
Operating Instructions, 10/2013, J31069-D0191-U001-A6-7618
SIMATIC RF310M Mobile Reader