Table of Contents
Advertisement
• "Installation Guidelines" on page 30
2. Turn off the corresponding DWC tray that you are going to perform the task on.
3. Remove the tray (see "Remove a DWC tray from the enclosure" on page 32).
4. Remove the tray cover (see "Remove the tray cover" on page 34).
You can find the DIMM tool attached to the air baffle.
Figure 18. DIMM tool
Attention: Memory modules are sensitive to static discharge and require special handling. In addition to the
standard guidelines for Handling static-sensitive devices:
• Always wear an electrostatic-discharge strap when removing or installing memory modules. Electrostatic-
discharge gloves can also be used.
• Never hold two or more memory modules together so that they touch. Do not stack memory modules
directly on top of each other during storage.
• Never touch the gold memory module connector contacts or allow these contacts to touch the outside of
the memory-module connector housing.
• Handle memory modules with care: never bend, twist, or drop a memory module.
Complete the following steps to remove a DIMM.
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-BHNs9o9uS9u93aeU5BCI8I
• Youku:
http://list.youku.com/albumlist/show/id_51372950.html
Step 1.
Remove the DIMM cover.
.
Chapter 3
Solution hardware setup
35
Advertisement
Table of Contents
