Figure 41. M.2 backplane installation
Step 1.
Align the openings located at the bottom of the blue plastic supports at each end of the M.2
backplane with the guide pins on the system board; then, insert the backplane in the system board
connector. Press down on the M.2 backplane to fully seat it.
After you install the M.2 backplane, complete the following steps:
1. Reinstall the tray cover (see "Install the tray cover" on page 61).
2. Reinstall the tray (see "Install a DWC tray in the enclosure" on page 63).
3. Check the power LED on each node to make sure it changes from fast blink to slow blink to indicate
both nodes are ready to be powered on.
Install a drive
Use this information to install a drive.
Before you install a drive:
1. Read the following section(s) to ensure that you work safely.
• "Installation Guidelines" on page 30
Complete the following steps to install a drive.
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-BHNs9o9uS9u93aeU5BCI8I
• Youku:
http://list.youku.com/albumlist/show/id_51372950.html
Step 1.
Squeeze two release latches to release the drive cage.
.
Chapter 3
Solution hardware setup
55