Table of Contents
Advertisement
Figure 46. PCIe riser-cage assembly installation
d.
Slide the retaining clamp underneath the heat pipe; then, rotate the clamp over the heat pipe in
the trough.
e.
Secure the clamp by inserting and tightening two silver Torx T10 screws.
Figure 47. Screws and retaining clamp installation
After you install an adapter, complete the following steps:
1. Reinstall the tray cover (see "Install the tray cover" on page 61).
2. Reinstall the tray (see "Install a DWC tray in the enclosure" on page 63).
3. Check the power LED on each node to make sure it changes from fast blink to slow blink to indicate
both nodes are ready to be powered on.
58
ThinkSystem SD650 Dual Node DWC Tray and NeXtScale n1200 DWC Enclosure Setup Guide
Advertisement
Table of Contents
