Electrical System - Husqvarna 326 E Workshop Manual

2
14

Electrical system

Attach the ignition coil to the ignition
cable.
Still no spark?
Check other cables and connections.
Still no spark?
Check the air gap.
502 51 34-02
Adjust the air gap.
Attach the ignition coil to the ignition cable
and ensure that the wire is folded along
the cable.
Slide the contact coil into the spark plug
cover.
TIP!
Lubricate the hole in the spark plug cover
so that it is easier to slide in the contact
coil.
Still no spark?
Check other cables and connections for
poor contacts (dirt, corrosion, cable brea-
kage and damaged insulation).
Make sure that the cables are correctly
drawn and lie in the cable grooves.
Do not forget to check the cables in the
throttle too.
See chapter 3 "Throttle".
TIP!
Use an Ohmmeter in order to easily check
if cable breakage has occurred, due to
pinching, for example.
Still no spark?
Check the air gap between the fl ywheel
magnet and the ignition module. The gap
should be 0.3 mm.
Use a 502 51 34-02 feeler gauge.
Adjust the air gap as needed to the correct
value.
• Loosen the bolts.
• Position the feeler gauge and press
the ignition module against the fl y-
wheel.
• Tighten the bolts and check the air gap
again.
If the spark plug still does not fi re, the igni-
tion system should be replaced.