Husqvarna 326 E Workshop Manual page 29

3
28
Fuel system
Dismantle the main jet (A) and the plug
(B).
Check valves and dampers for wear.
Replace if required.
Pull away the movement limiters on the jet
screw needles using a long nosed pliers
or the special tool 504 62 29-01 if the mo-
vement limiter is made of plastic and 540
06 82-01 if it is made of zinc.
Unscrew the jet needles.
Do not lose the small washers (A)!
NOTE!
Note how the jets are positioned.
(For example, the H-needle is a little
shorter than the L-needle).
531 00 48-63
504 62 29-01 (plast)
540 06 82-01 (zink)
Press out the main jet (A) with a suitable
punch.
Remove the plug (B).
Carefully drill a small hole (Ø 2 mm) in the
plug and pry it up with a pointed object.
Remove the valves and dampers. If these
components are worn, idling is disrupted.
Always replace the valves and dampers at
the same time.