Dismantling, Model 326 - Husqvarna 326 E Workshop Manual

Starter
Assemble the starter handle.
Tension the return spring.
Check the spring tension.
Fit the starter on the engine body.
Dismantling
Model 327P5
Remove the handle bow from under the
engine body.
Remove the 3 screws and lift off the starter.
NOTE!
Ensure the bushings (A) that guide the starter towards the fuel tank are not
lost.
502 50 18-01
Assemble the starter handle.
Tie a double knot on the cord and fold under
the free end.
Pull the knot fully into the handle.
Tension the return spring.
Pull the starter cord out completely and slow
the starter pulley with your thumb.
Lift the cord into the notch on the starter
pulley.
Now turn the starter pulley anticlockwise,
6 turns.
Check the spring tension. With the starter
cord fully extended it should still be possible
to turn the starter pulley further, at least a
half turn.
Fit the starter on the engine body and check
that the drive dog engages.
Dismantling
Model 327P5
Remove the three screws (A) and remove
the handle bow.
1
7