Silvercrest SSB 50 A1 Operating Instructions Manual page 6

vases or something similar filled with liquid on or in
the vicinity of the device.
Never touch the device and power unit with wet
hands.
Pull the power unit out of the wall socket if liquid gets
into the device.
Should liquid enter the device, have it checked by an
expert before starting the device up again.
DANGER! Risk of electric shock
Never put the device into operation if there are visible
damages to the device, the power unit or the cable or
if the device has been dropped before. Do not use the
device again, but have it checked by a specialist work-
shop.
Never open the casing of the device or power unit.
Connect the cable to the device before plugging the
power unit into a wall socket.
Only connect the power unit to a properly installed,
easily accessible wall socket, the voltage of which cor-
responds to the specifications on the rating plate. The
wall socket must continue to be easily accessible after
the device is plugged in.
Ensure that the cable cannot be damaged by sharp
edges or hot surfaces.
Ensure that the cable is not trapped or crushed.
When removing the power unit from the wall socket,
always pull the power unit and never the cable.
Pull the power unit out of the wall socket, ...
... if there is a fault,
... before connecting the device to the power unit,
... before you clean the device and
... during thunderstorms.
For a complete mains separation, pull the power unit
out of the wall socket. Even if it is switched off, a small
amount of power is always used as long as the power
unit is plugged in.
To avoid any risk, do not make modifications to the de-
vice. Repairs must be carried out by a specialist work-
shop or the Service Centre.
Batteries
Be sure to observe the correct polarity when inserting
the batteries.
Clean the battery and possibly device terminals before
you insert the batteries.
DANGER OF EXPLOSION! Batteries must
not be charged or reactivated by other means,
nor must they be dismantled, thrown into a fire
or short-circuited.
Remove the batteries from the remote control if you do
not intend to use the remote control for an extended
period, or if the battery runs out of power. The batter-
ies might leak and damage the remote control.
Do not subject batteries to extreme conditions, e.g. do
not place the remote control on radiators or expose it
to direct sunlight. Otherwise, there is an increased
danger of batteries leaking.
4
GB
If battery acid has leaked, avoid contact with the skin,
eyes and mucous membranes. In case of contact with
the acid, rinse the affected area at once with plenty of
clean water and seek medical assistance immediately.
Batteries can be life-threatening if swallowed. There-
fore you should store batteries out of the reach of
young children. If a battery has been swallowed, med-
ical assistance must be sought immediately.
Keep new and used batteries away from children.
If you think the batteries could have been swallowed
or have gotten into any part of the body, seek medical
help immediately.
WARNING! Risk of material
damage
Only use the included original power adaptor for
mains operation.
If you notice any irregularities (e.g. unusual noises,
strange smells or smoke developing), pull the power
unit out of the wall socket immediately. Do not use the
device any longer.
If the device is moved from a cold location to a warm
location, condensate may form in the device. Leave
the device switched off for approx. 2 hours to become
acclimatised.
Place the device on a stable, flat surface.
Protect the device against damage, e.g. from:
- Heat, direct sunlight and open flames
- Impacts and similar violent effects
Candles and other open flames must be kept
away from this product at all times in order to
prevent the spread of fire.
Do not cover the power unit to prevent overheating.
Do not use any astringent or abrasive cleaning agents.
The device is fitted with non-slip plastic feet. As furni-
ture is coated with a wide array of varnishes and syn-
thetics, and is also treated with different care products,
it cannot be fully ruled out that some of these materials
contain ingredients that could attack and soften the
non-slip plastic feet. If necessary, place a non-slip mat
under the device.
Please ensure the following when mounting on a wall:
- The fixing material must be matched to the proper-
ties of the wall. If necessary, use fixing material other
than that supplied.
- Make sure that in the installation location there are no
pipes or cables in the wall (e.g. electricity, water, gas).
- If necessary, have the wall mounting carried out by
an expert.
Notes on Bluetooth
Radio waves are potentially able to affect or even in-
terfere with the operation of heart pacemakers, (sensi-
tive) electronic devices and other radio waves (e.g.
WLAN). Therefore, please observe the following
notes.
- People wearing heart pacemakers, should maintain
a distance of 20 cm to the product.
- Radio waves may cause interferences, e.g. in mobile
phones or hearing aids.
®