Installation And Configuration Checklist - Hitachi Universal Storage Platform V Configuration Manual

Installation and Configuration Checklist

Table 2-1
operating system. The two columns on the left indicate requirements to be met,
tasks to be completed, and information to be obtained before you perform the
installation. Use the column on the right to confirm that you have the required
minimum requirements and completed the task. You can also write any notes
about a requirement.
Table 2-1
Installation
Requirements
Hitachi USP V system,
all-open or
multiplatform
configuration
SGI IRIX system
hardware
SGI IRIX operating
system, version 6.5.x
(6.5.16 and 6.5.24
are under evaluation)
Fibre-channel HBAs
Fibre-channel utilities
and tools
2-2
Hitachi Universal Storage Platform V/VM Configuration Guide for SGI
is a checklist for installing and configuring the USP V on an SGI IRIX
Installation and Configuration Checklist
The availability of features and devices depends on the level
of microcode installed on the USP V.
Use LUN Manager software to configure the fibre-channel
ports. If this feature is not installed, contact your Hitachi
Data Systems account team.
SGI O2
Octane
Onyx2
Challenge
®
Origin
Please contact your Hitachi Data Systems account team for
further information on server hardware requirements.
Root login access to the SGI IRIX system is required. Please
contact Silicon Graphics
current OS patches are installed on the SGI systems(s). For
the latest information about SGI IRIX version support,
contact your Hitachi Data Systems account team.
The USP V supports fibre-channel HBAs equipped as follows:
4 Gbps fibre-channel interface, including shortwave non-
OFC (open fibre control) optical interface and multimode
optical cables with LC connectors.
2 Gbps fibre-channel interface, including shortwave non-
OFC (open fibre control) optical interface and multimode
optical cables with LC connectors.
1 Gbps fibre-channel interface, including shortwave non-
OFC optical interface and multimode optical cables with
SC connectors.
If a switch or HBA with a 1Gbps transfer rate is used,
configure the device to use a fixed 1Gbps setting instead of
Auto Negotiation. Otherwise, it may prevent a connection
from being established.
Do not connect OFC-type fibre-channel interfaces to the
USP V. For information about supported fibre-channel HBAs,
optical cables, hubs, and fabric switches, contact your
Hitachi Data Systems account team.
Refer to the documentation for your fibre-channel HBA for
information about installing the utilities and tools for your
adapter.
Installing the USP V
Description
®
®
®
200
®
to make sure that the most
Requirements
Confirmed?
® ®
IRIX Host Attachment