Status Of The Card Access Lamp And Memory Card; Inserting/Removing The Memory Card - Panasonic AG-CX350 Operating Instructions Manual

Status of the card access lamp and memory card

Card access lamp
Orange (illuminated)
Green (illuminated)
Orange (flashing)
Orange (rapidly flashing)
Green (slowly flashing)
Off
@
NOTE
t The card access lamp will not illuminate or flash when the [OTHERS] menu → [LED] → [ACCESS LED] → [OFF] is set.

Inserting/removing the memory card

Inserting the memory card
The memory card to use with the camera should always be formatted on the camera. (page 43)
f Formatting the memory card will erase all of the recorded data which cannot be restored.
Card 2 access lamp
1
Open the card slot cover.
2
Insert the memory card into the card slot.
f Card slot 1 and card slot 2 can each insert one memory card.
f Insert straight in with the label facing left until it clicks.
Do not force or apply excess force when inserting the memory card.
3
Close the card slot cover.
Removing the memory card
1
Open the card slot cover.
f Confirm that the card access lamp is not flashing in orange.
f Data is being written/loaded when the card access lamp is flashing in orange, so do not remove the memory card.
2
Press in the memory card further into the camera and let go.
Chapter 3 Preparation — Preparing the memory card
Recording target
Recording possible
Accessing card
Recognizing memory card
Error
No remaining recording capacity
Write-protected
Recording not possible
No memory card inserted
Illegal format
Card not supported
Setting to [NETWORK] menu →
[NETWORK FUNC] → [NDI|HX]
During card reader mode
Card slot 1 Card 1 access lamp
Card slot 2
– 42 –
Memory card status
Both loading/writing are permitted. Current recording target.
Both loading/writing are permitted.
Loading/writing are currently being performed.
The memory card is being recognized.
An error has occurred. This will flash even if the memory card is not
inserted when an error has occurred.
No recording capacity left on the memory card. Only loading is possible.
The write-protection switch of the memory card is set to the LOCK side.
It cannot record with the recording format that is currently set. Change
the recording format or use a memory card compatible with the recording
format to record.
A memory card has not been inserted.
It is not the correct format. Reformat the card.
This is a card that cannot be used with the camera, such as MMC (Multi
Media Card).
Cannot record and play back. The functions other than recording and
playback (loading of the scene file, etc.) can be used.
The card 1 access lamp/card 2 access lamp turns off when not
accessing.
Card slot cover