Siemens SIMATIC NET Operating Instructions Manual page 50

Approvals
● Keep to the installation guidelines
The product meets the requirements if you adhere to the installation and safety
instructions contained in this documentation and in the following documentation when
installing and operating the product.
● You can always find the latest documentation on the Internet
The current descriptions of the currently available products can always be found on the
Internet under the specified entry IDs/Internet pages:
– SIMATIC NET Industrial Ethernet Network manual
– EMC Installation Guideline, Planning Guide
– Working on the product
Machinery directive
The product is a component in compliance with the EC Machinery Directive 2006/42//EEC.
According to the machinery directive, we are obliged to point out that the product described
is intended solely for installation in a machine.
Before the final product can be put into operation, it must be tested to ensure that it conforms
with the directive 2006/42/EEC.
Note
Note for the manufacturers of machines
This product is not a machine in the sense of the EC Machinery Directive. There is therefore
no declaration of conformity relating to the EC Machinery Directive 2006/42/EEC for this
product.
50
ID = 27069465 (http://support.automation.siemens.com/WW/view/en/27069465)
ID = 60612658 (http://support.automation.siemens.com/WW/view/en/60612658)
To protect the product from electrostatic discharge, personnel must first discharge any
electrostatic charge from their body before touching the product.
Note
The product was tested with a device that also complies with the standards listed
above.
If the product is operated with a device that does not meet these standards, there is
no guarantee that the corresponding values will be adhered to.
Operating Instructions, 10/2013, C79000-G8976-C297-02
SCALANCE XC100-4OBR