ABB -free@home SAP/S.3 Product Manual page 39

C: Connect the System Access Point via WLAN with the router after commissioning.
– This connection must be carried out via the network settings of the user interface. There
select the name of the network with which you want to connect the System Access Point
and enter the network key.
– The System Access Point receives an IP address from the router automatically.
– During the attempt to connect, the connection display flashes.
– After the connection has been successfully established the connection display lights up
permanently.
The access point mode can be activated again at any time. If the access point mode is
deactivated, the LAN client or (if it has been configured) the WLAN client mode is activated.
Product manual 2CKA001473B9726
NOTE
The list of recommended network names (SSIDs) is created during the boot-
up process of the System Access Point. The WLAN networks that cannot be
reached at this point will not be shown in the list of recommendations.
Commissioning
│39