Accessory (included): none
User-supplied (not included): RJ45 connector
Notes
•
LINE 5 to LINE 8 are for BRI8 card only.
•
Connect these optional service cards to the trunk through NT1; do not connect to the trunk
directly.
•
These optional service cards have 100
point connection, the cards must be placed at the end of the bus.
PRI30/PRI23 Card
Example: PRI30 Card
To NT1
To NT1
For BNC
Accessory (included): ferrite core × 1
User-supplied (not included): RJ45 or BNC connectors
Notes
•
In some countries/areas, the PRI30 card must not be connected to the Public Switched
Telephone Network.
•
Connect these optional service cards to the trunk through NT1; do not connect to the trunk
directly.
•
Use only 1 type of connector (RJ45 or BNC) for connection of PRI30 card; RJ45 and BNC
cannot be used simultaneously. Set the termination switch to 120
connector type to be used.
•
When connecting the RJ45 connector, attach the included ferrite core (except in Canada,
where the ferrite core is not necessarily be attached).
8
Getting Started
RJ45
TX+
TX-
RX-
RX+
For RJ45
120Ω
120Ω
OR
75Ω
75Ω
of terminal resistance. For use of point to multi-
BNC (TX)
TX+
TX-
BNC (RX)
RX-
RX+
To attach the ferrite core
5 cm
(default) or 75
for