Hitachi Compute Blade 500 Series Function Manual page 17

11. Repeat the above steps for the other network devices.
12. After doing the above steps for all network devices, select any of the network
devices and then select [Action]-[Scan for hardware changes].
All network devices are detected and the installed LAN driver software is applied to
the network devices.
13. Check the IP address setting for each of the network devices. When you set an IP
address for a network device, you can find out the check box "Obtain an IP address
automatically" is checked as a default. To specify an IP address, it's necessary that
you change the IP address setting. After changing the IP address setting, check if
the network cable is connected to the destination or not, and then reboot the guest
OS.
When you set up the LAN driver, the message showing that the LAN driver
cannot be used might be displayed. In this case, you can set up normally by
rebooting a guest OS. Then, check if the device works normally or not in
Computer Management window.
Restriction on changing parameters for network adapters. After you change the
parameters for network adapters, the network adapters might not communicate
normally. In this case, check the updated netwrok adapters in Computer
Management window. If "!" for a network adapter is displayed, right-click the
network adapter. Next, disable the network adapter and then enable the network
adapter again.
Hitachi Compute Blade 500 Series LAN Advanced Function Manual (for Intel)
Updating LAN driver 1-9