Table of Contents
Advertisement
CONNECTING THE S5U1C33001H AND THE HOST COMPUTER
Connecting the AC Cable
The S5U1C33001H uses a 3-wire (grounded) AC power cable.
Connect the AC frame ground of the host computer and the S5U1C33001H to a common frame ground as shown in the
figure below.
Connecting the USB Cable
The connectors at each end of the USB cable are type A (for the host computer) and type B (for the S5U1C33001H).
Turn on the S5U1C33001H power and connect the USB cable to the host computer. The host computer will request that the
USB driver be installed.
Use the procedure described in the next section to install the USB driver.
Note: The USB driver is located in the directory in which the S5U1C33001C (S1C33 Family C Compiler Package) is
installed: C:\gnu33\utility\drv_usb.
Host computer
AC connector
Frame ground line
Figure 12 AC and Frame Ground Lines
Host computer
USB
Figure 13 Connecting the USB Cable
S5U1C33001H
S5U1C33001H (rear panel)
O
I
AC cable
AC line
S5U1C33001H (rear panel)
O
I
USB connector
(Ver. 4)
11
Advertisement
Table of Contents
