Connecting The Target System - Epson S5U1C33001H Manual

CONNECTING THE TARGET SYSTEM

Use the 30-pin, 10-pin or 4-pin target system interface cable supplied with the S5U1C33001H package to connect the target
system. The target system must have a connector for connecting the above cable. For this, use the 30-pin, 10-pin or 4-pin
target connector supplied with the S5U1C33001H package or an equivalent connector. The pin assignment of the target
connector is shown in the tables below. For each signal pin number of the S1C33xxx chip, refer to the "S1C33xxx Technical
Manual" of the specific model.
10-pin connector
No. Pin name I/O
1 DCLK I Clock for debugging
2 GND – Power supply (GND)
3 DSIO I/O Serial I/O signal for debugging
4 GND – Power supply (GND)
5 DST2 I Debug status 2 signal
6 GND – Power supply (GND)
7 DST1 I Debug status 1 signal
8 GND – Power supply (GND)
9 DST0 I Debug status 0 signal
10 DPCO I PC signal
30-pin connector
No. Pin name I/O
1 GND – Power supply (GND)
2 DCLK I Clock for debugging
3 GND – Power supply (GND)
4 DSIO I/O Serial I/O signal for debugging
5 GND – Power supply (GND)
6 DST2 I Debug status 2 signal
7 GND – Power supply (GND)
8 DST1 I Debug status 1 signal
9 GND – Power supply (GND)
10 DST0 I Debug status 0 signal
11 GND – Power supply (GND)
12 DPCO I PC signal
13 GND – Power supply (GND)
14 DTS4 I Bus trace status 4 signal
15 DTS3 I Bus trace status 3 signal
Target connector
(30 pins)
Target I/F cable
Target system
(30-30 pins)
S1C33xxx
or
Target I/F cable
(10-10 pins or 10-4 pins)
Target connector
(10 pins or 4 pins)
Figure 14 Connecting the Target System
Table 9 Pin Assignment of Target Connectors
9 1
• • • • •
• • • • •
10 2
Pin function
Pin function
S5U1C33001H
or
S 5 U 1 C 3 3 0 0 1 H
4-pin connector
No. Pin name I/O
1 DCLK I Clock for debugging
2 GND – Power supply (GND)
3 DSIO I/O Serial I/O signal for debugging
4 DST2 I Debug status 2 signal
No. Pin name I/O
16 DTS2 I Bus trace status 2 signal
17 DTS1 I Bus trace status 1 signal
18 DTS0 I Bus trace status 0 signal
19 GND – Power supply (GND)
20 DTD7 I Bus trace data 7 signal
21 DTD6 I Bus trace data 6 signal
22 DTD5 I Bus trace data 5 signal
23 DTD4 I Bus trace data 4 signal
24 GND – Power supply (GND)
25 DTD3 I Bus trace data 3 signal
26 DTD2 I Bus trace data 2 signal
27 DTD1 I Bus trace data 1 signal
28 DTD0 I Bus trace data 0 signal
29 GND – Power supply (GND)
30 DBT I Bus break trigger signal
(Ver. 4)
EPSON
• • • •
4
Pin function
30 1
Pin function
1
13