Optimizing The Recording Condition - Sony CCD TRV 64 E Operating Instructions Manual

Optimizing the recording condition

Use this feature to check the tape condition before recording, so that you can get the
best possible picture (ORC).
(1) While the camcorder is in Standby mode, press MENU to display the menu.
(2) Turn the control dial to select ORC TO SET, then press the dial.
"START/STOP KEY" flashes.
(3) Press START/STOP.
The camcorder takes about 5 seconds to check the tape condition and then
returns to Standby mode.
1
MENU
Each time you insert the cassette
Perform the above procedures.
To see if the tape condition has been checked
If the ORC indicator lights up in the display window, the tape condition has been
checked.
Notes on the ORC function
• When you set ORC TO SET, the recording on the tape is erased for about 0.1 second
so that the camcorder can check the tape condition. Be careful when you use a
recorded tape. The 0.1 second blank is erased if you record from the point where you
set ORC TO SET for more than 2 seconds, or if you record over the blank.
• You cannot use this function on a tape with the red mark on the cassette exposed.
46
2
1
MENU
WIND
COMMANDER
ORC TO SET
REC MODE
TITLE COL
TITLE POS
TITLE1 SET
[MENU]: END
3
START/STOP
2
ORC
START/STOP
KEY
STBY
0:00:00