Table of Contents
Advertisement
Table 3 shows lamp indications for the PA-24PRT card.
LAMP NAME
OPE Note
N-OPE
PCM
FRM
BER
RMT
AIS
DOPE Note
LYR Note
PKT
BL00
BL23
When the card is fully operational and communicates with the C.O. PRI, observe
Note:
these LEDs (OPE, DOPE, LYR).
5.
DATA ASSIGNMENT
5.1
ISDN PRI Commands
The following list provides ISDN PRI commands. Use ISDN PRI only with LCR.
ASYD
ARTD
ATRK
ARSC
ARRC
Page 11
Table 3 Lamp Indications
COLOR
Green
Remains lit while this circuit card is operating.
Red
Remains lit while this circuit card is in make-busy state.
Red
Lights in the case of input signal down (PCM LOSS).
Red
Lights in the case of frame alignment loss.
Red
Lights when CRC error occurs frequently.
Red
Lights on receiving remote office alarm.
Yellow
Lights on detection of AIS.
Green
Remains lit while the D Channel Controller is on.
Green
Lights when the link of the D channel is set up.
Green
Lights when the packet of the D channel is in use.
Green
Lights when the corresponding circuit is busy.
Flash
Flashes while the corresponding circuit is in make-busy
state.
OFF
Remains off when the corresponding circuit is idle.
(BL23 is always on because the D Channel is in use.)
Index 186 bit 6 ON for ISDN to be turned ON.
Index 375 bit 0 ON for releasing of trunk lockup.
Assign the D channel route and the B channel. See paragraph
information.
Assign the B channels and D channels. See
information.
Assign restriction class.
Assign only if Route to Route connection is necessary.
NEAX2400 ICS ISDN PRI Installation Notes
STATE
Figure 1
and
5.3
for more
Figure 3
for more
ETI-152A
Advertisement
Table of Contents
