Table of Contents
Advertisement
NEAX2400 ICS ISDN PRI Installation Notes
ADPC
ACIC
ACSC
MBTK
AMND
ARNP
AFRS
AOPR
ACBC
ACNP
ACND
ACDD
ASFC
AANDE
5.2
ASYD Command
SYSTEM
SYSTEM1
SYSTEM1
NOTE:
INDEX 187=00, Number of DCH, is not used when ISDN ICS uses the PA-24PRT
card.
ETI-152A
Assign the determined point code. Same point code is used for the B and D
route of one interface. If more than one ISDN link is used and no NFAS is used,
each interface will have a different point code.
Assign the point code to a CSC without LEN.
Assign the CSC even and odd to the DCH LEN. See paragraph
information.
Idle all the TK, including the D channels.
Assign the necessary number of digits. Data numbers for CCIS or ISDN should
be set as Digital A/D=1.
Assign the B route access code.
Assign the necessary numbers for specific OPRs.
Assign the route of the B channels.
Assign the services associated with the specific OPR, if necessary.
Assign CNP per route used for sending the CPN to the network.
Assign the area code office code for the CPN.
Assign the DNIS incoming number conversion, if necessary.
Assign the Presentation Restricted or CPN/BN Preferred.
Assign an office code and NPA combination per each tenant for multiple CPNs
(overrides ACNP and ACND).
ASYD
INDEX
INDEX186
INDEX375
DATA ASSIGNMENT
Bit 6 = 1 for ISDN in Service
Bit 0 = 1 for releasing of trunk lockup
5.5
for more
Page 12
Advertisement
Table of Contents
