Using The Appliance; Fitting/Removing The Attachments; Epilation - Silvercrest SBT 3.6 D2 Operating Instructions Manual

Using the appliance

Fitting/removing the attachments

All of the supplied attachments (epilator head
and micro trimmer
orientation of the attachment to the hand element
The curvature of the attachments must always be towards the side of the hand element
on which the on/off button
♦ To fit an attachment, press it onto the appliance (see Fig. 1)
♦ To remove an attachment, pull it off the appliance (see Fig. 2)

Epilation

When the appliance is charged and the body part to be epilated is prepared:
1) Rub your hand once more against the growth direction of the hairs to be removed.
This will raise the hairs so that they can be better captured by the tweezers.
2) Fit the epilator head
head must be facing towards the side of the hand element
off button is located (see chapter "Fitting/removing the attachments").
3) Push the on/off switch
4) Hold the skin tight with one hand.
5) Place the appliance perpendicular to the skin and, without exerting any pressure,
move it against the direction of the hair growth. Do not make back and forth or
circular movements. Move the appliance slowly with calm and gentle movements.
Always start anew and pass over the body part to be epilated several times, so that
all of the hair is removed.
NOTE
► It is possible that some hairs will grow back after a few days. The reason for this
is that these hairs were too short to be removed during the last epilation session.
SBT 3.6 D2
) can be fitted and removed in the same manner. Ensure the correct
is located.
(Fig. 1)
on the hand element
in the direction of the attachment.
, precision trimmer
:
. The slight curvature of the epilator
GB │ IE │ NI
, micro shaver
;
(Fig. 2)
on which the on/
│
9 ■