Dell EqualLogic PS4210 Hardware Owner's Manual page 20

PS4210 Hardware Owner's Manual
Verify that the new drive is operational by examining the LEDs on the front panel, as described in
Drive LEDs on page 7. In addition, examine the GUI Member Disks window and the CLI
command output.
disks
Removing a Drive Blank
To maintain proper system cooling, all empty drive slots must have drive blanks installed.
1. Remove the bezel. See
2. Press the release tab and slide the drive blank out until it is free of the drive slot. See
and the callouts in.Table
Figure 12: Removing and Installing a 3.5-Inch Hard-Drive Blank
Figure 13: Removing and Installing a 2.5-Inch Hard-Drive Blank
Installing a Drive Blank
1. Remove the bezel. See
2. Insert the drive blank into the drive bay until the blank is fully seated.
3. Attach the bezel.
14
Removing the Bezel on page
5.
Table 5: Hard Drive Blank Callout Values
Item Description
1 Drive blank
2 Release tab
Removing the Bezel on page
2.
2.
2 Maintaining Drives
Interpreting
member select show
Figure 12 or Figure 13