Did Translation Table - NEC Electra Elite IPK II Pc Programming Manual

Document Revision 1
7.0
18
Basic Settings
Details basic characteristics of the selected Department Group. These settings
are linked with 16-01.
Primary Members
Lists all extensions that are Primary Members of the selected Department Group.
Every extension must belong to one of the 64 available Department Groups. By
default, all extensions are Primary Members of Department Group 1. By removing
an extension from Department Group 1 it is automatically assigned to Department
Group 64. These settings are linked with 16-02.
When an extension is selected as a Primary member it will automatically appear in
the priority list (the list to the bottom of the Primary Member list). The priority of the
selected extension can be modified by the following key combinations:
J Shift + Up Arrow
J Shift + Down Arrow
J
Shift + Page Up
J
Shift + Page Down
J Shift + Home
J
Shift + End
Secondary Members
Lists all extensions that are Secondary Members of the selected Department
Group. A maximum of 16 extensions can be assigned as Secondary Members.
These settings are linked with 16-03.
When an extension is selected as a Secondary member it will automatically
appear in the priority list (the list to the bottom of the Secondary Member list). The
priority of the selected extension can be modified by using the same key
combinations as in the case of setting the priority for Primary Members.
DID T
RANSLATION
This screen combines system data relevant to the DID Translation Table and
Trunk Groups using DID. These settings are used with the KTS feature "Direct
Inward Dialing". To setup the DID Translation Table and associate it with Trunk
Groups complete the following:
Increase priority by 1
Decrease priority by 1
Increase priority by one page
Decrease priority by one page
Make highest priority
Make lowest priority
T
ABLE
Electra Elite IPK II
Standard View