Handling And Operation; Filling With Water - Silvercrest SDM 1500 D2 Operating Instructions Manual

Handling and operation

This section provides you with important information on handling and using the
appliance .

Filling with water

CAUTION! PROPERTY DAMAGE!
► Never operate the appliance without water in the water tank 8!
The pump could overheat and be damaged!
► Do not fill the water tank 8 with any cleaning agents or other additives .
1) Push the "Water tank" release button 9 upwards and simultaneously
remove the water tank 8 .
2) Turn the water tank 8 and unscrew the cap .
3) Fill the water tank 8 with tap water up to the MAX mark .
NOTE
If the mains water in your location is rated as hard, it is recommended
that you mix the mains water with some distilled water . Otherwise, the
jets for the steam blast function could calcify (become blocked)
prematurely .
To extend the optimal steam blast function, mix mains water with distilled
water according to the table:
Water hardness
The water hardness level can be queried at your local water works .
4) Attach and hand­tighten the clamp .
5) Turn the water tank 8 around again and place it back onto the main unit 3:
First fit the lower part into the main unit 3 and then flip the top part into the
device . Push it firmly into place so that the water tank 8 audibly clicks into
place and sits firmly on the main unit 3 .
SDM 1500 D2
water to tap water
very soft/soft
medium
hard
very hard
Ratio of distilled
0
1:1
2:1
3:1
27 ■
GB │ IE │