Install The Stain Pak - Siemens Hematek Operating Manual

Install the Stain Pak

1. Remove the perforated tabs from the Hematek Stain Pak. Insert the carton, with the
STAIN
2. Make sure the carton is all the way down and resting on the tray at the bottom of the
well. The carton should be level when properly installed.
Figure 2-5. Installing the Stain Pak
3. Insert the appropriate cannula into its respective bottle by puncturing the center of the
indentation on the bottle.
Figure 2-6. Installing Cannula into Stain Pak Bottle
Section 2: Installation, Page 2—9
bottle to the right, into the well at the rear of the instrument.