Power Light; Low Stain Light; Power Module; Line Cord Receptacle - Siemens Hematek Operating Manual

POWER Light

The green
the instrument is turned on, the light illuminates.

LOW STAIN Light

The yellow
operating conditions; however, when the Hematek Stain Pak contains sufficient reagents
to stain only about 20 slides, a weight-sensing device activates the circuit and illuminates
the light. The Stain Pak should be replaced at this time.

Power Module

The power module is located on the rear of the instrument; on one side of the module is
the panel that contains the line cord receptacle, fuse, and power switch. The power module
converts the line current coming into the instrument to 12 volts DC, which is the voltage
within the instrument.
Figure 1-8. Electrical System–Rear of Instrument
1

Power Module

2 ON / OFF Switch
3 Fuse Holder
4

Line Cord Receptacle

Line Cord Receptacle

The line cord connects into the line cord receptacle, which is located at the top of the panel
on the power module.
Page 1—12, Section 1: Introduction
light is located at the right side of the instrument near the top. When
POWER
light is to the left of the
LOW STAIN
light. It is off under usual
POWER