Integrator Modes - Pioneer PDP-503CMX Product Training Manual

Integrator Mode
Integrator Mode
About the integrator mode
1) How to enter integrator mode
• Place the unit in integrator mode by doing the following:
Procedure: In standby, switch on power to the unit using the e remote control or the operating panel of the main
unit, as follows:
MENU button = POWER button
(This procedure should be complete in three seconds.)
2) Upon entering the integrator mode
• The content of picture quality adjustment and picture location adjustment that are adjusted in menu mode are all
initial values. The content of SET UP and OPTION are maintained, but COLOR TEMP becomes MIDDLE.
3) When you make adjustments in integrator mode:
• The adjusted values of PICTURE, WHITE BALANCE, and SCREEN (see 5.4.3 1) ~ 3)) are stored in memory for
each input function and input signal.
However, regarding PICTURE WHITE BALANCE during PC signal input, up to 8 kinds of input signals (signal
frequencies) can be stored in memory for each function.
When 9 new kinds of input signals have been adjusted, the adjustment data for the input signal that has the
longest history of adjustments is erased.
• For more details please refer to "5.4.5 PICTURE and WHITE BALANCE adjustment values memory area tables"
and "5.4.6 SCREEN adjustment values memory area tables".
4) To exit integrator mode
• Press the MENU button on the remote control or on the operating panel of the main unit to restore the unit to
normal operating mode.
5) NOTES:
(1) The input can't be switched while in the integrator mode.
Make sure you have switched to the appropriate input before entering the integrator mode.
It is also important to plug in signals beforehand.
(2) Integrator mode is cancelled automatically in all of the following situations, returning to normal operating mode.
• When switching over to another input signal mode (i.e., to another signal frequency)
• When no operation occurs for a period of approximately three minutes
• When you press the KEY LOCK/UNLOCK button on the operating panel of the main unit
(3) For adjustments and settings, feed video signals that you will actually use into the production run.
66