Motorola APX Series User Manual page 57

Connect two radios with a clone cable. The target radio
must be digital, band, and FCC mandate compatible with
the source radio.
1 On the source radio, press the Menu Select button
directly below Clon.
2 Press the Menu Select button directly below Sel to
select source zone.
3 When connecting to the target radio, one of the
following scenarios occurs:
• If the radio is compatible, the radio displays
Target radio connected. Proceed to
• If the radio is not compatible, the radio displays
Target radio incompatible. Press the Menu
Select button directly below Ok and the radio
returns to the previous screen.
Once connected, the zone clone status is displayed
on the right.
4 Press the Menu Select button directly below Next to
accept the source zones selection. One of the
following scenarios occurs:
• If you select a single source zone, press the
Menu Select button directly below Sel to select
the target zones for cloning.
• If you select multi-source zones, the radio
displays Confirm target and shows the
automatically selected target zones and source
zones mapping.
5 Press the Menu Select button directly below Clon to
begin cloning.
The radio displays Cloning...<Current cloning zone>.
One of the following scenarios occurs:
step 4.
• If the cloning is successful, a tone sounds, the radio
displays Clone successful and the source zone alias
is displayed on the right.
• If the cloning is not successful, a tone sounds and the
radio displays Clone failed. Press the Back button to
enter the source zone list.
• If you press the Home button, the radio aborts cloning.
NOTICE:
The target radio enters programming mode during
cloning and resets after cloning is completed.
English
57