Over-The-Air Programming (Pop 25, Astro 25, And Astro Conventional) - Motorola APX Series User Manual

NOTICE:
The radio enables the sensor only when
all the guns or tasers are placed into the
holster. A tone sounds and the radio
displays Sensor On temporarily.
• If the timer expires without an event, a tone
sounds, the radio switches the sensor to enabled
state, and clears the sensor status from the
display.
• If the preprogrammed Sensor button is long-
pressed, the OTA sensor notification is enabled.
Disabling the Sensor Permanently
1 Long-press the preprogrammed Sensor button to
permanently disable the sensors.
A tone sounds and the radio displays Sensor Off.
While in this state, no events is reported over-the-air
(OTA), regardless of how many times the gun is
drawn, re-inserted or weapon is fired.
The radio generates a bad key tone if the sensor is
not allowed to be disabled or there is no sensor
connected to the radio when the preprogrammed
button or menu select button is pressed.
2 Long-press the preprogrammed Sensor button
again to enable the OTA Sensor notification.
A tone sounds, and the radio displays SNSR OFF.
Over-the-Air Programming (POP 25,
ASTRO 25, and ASTRO
Conventional)
This feature enables configuration data and firmware to be
upgraded to your radio over-the-air. Full use of the radio is
retained during the data transfer without interrupting
communication. For ASTRO 25 and ASTRO Conventional,
the upgrade pauses to give priorities to voice call, and
continues after the voice call ended. For Wi-Fi, the upgrade
process runs concurrently with voice calls.
Once a configuration upgrade is downloaded to your radio,
you can install new changes immediately or delay changes
to be installed on the radio when it is being powered up.
English
97