Sony WALKMAN MZ-NH1 Operating Instructions Manual page 83

Symptom
Playback sound skips.
Sound has a lot of
static.
The volume of the
recorded track is low.
Volume cannot be
turned up.
No sound comes
through the
headphones/earphones.
Virtual Surround or 6-
Band Equalizer does
not function or noise is
heard.
The volume from
connected speaker or
amplifier is low (when
analog connection)
The volume from the
headphones/earphones
is too loud.
The disc cannot be
played on another
component
The recorder skips to
the next or previous
group (or skips several
tracks ahead or behind)
when you press the 5-
way control key
towards . or >.
The edited tracks may
exhibit sound dropout
during search
operations.
Cause/Remedy
• The recorder is placed where it receives continuous vibration.
, Put the recorder on a stable place.
• A very short track may cause sound to skip.
, Try not to create a short track.
• Strong magnetism from a television or such device is interfering
with operation.
, Move the recorder away from the source of strong magnetism.
• The track was recorded in analog mode (in digital mode, the
recording level is automatically set to the same level as that of the
sound source). Or you used a connecting cord with an attenuator.
, Use a correct connecting cord without an attenuator.
• The recording level was low.
, Adjust the recording level manually while recording (page 38).
• AVLS is on.
, Release AVLS settings (page 66).
• The headphones/earphones plug is not firmly connected.
, Plug in the plug of the headphones/earphones firmly to the
remote control. Plug in the plug of the remote control firmly to
i/LINE OUT.
• The plug is dirty.
, Clean the plug.
• The "Audio Out" parameter is set to "Line Out".
, Set to "Headphone" (page 51).
• The "Audio Out" parameter is set to "Headphone".
, Set to "Line Out" (page 51).
• The "Audio Out" parameter is set to "Line Out".
, Set to "Headphone" (page 51).
• The component does not support Hi-MD.
, Discs used in Hi-MD
that supports Hi-MD.
• You pressed GROUP before pressing the 5-way control key
towards . or >.
, The recorder returns to normal if no operation is made for 5
seconds.
• This occurs due to the MiniDisc system limitation. The
fragmentation of data may cause sound dropout while searching
because the tracks are played in higher speed than normal
playback.
mode
can be played only on components
83