Sony WALKMAN MZ-NH1 Operating Instructions Manual page 91

Message Meaning/Remedy
PUSH STOP • You tried to open the lid by sliding the OPEN switch while the recorder
BUTTON
READ ERROR • The recorder cannot read the disc information correctly.
REC ERROR • Recording was not correctly done.
• The disc is soiled with an oil film or finger prints, is scratched, or is not a
SYSTEM FILE • The recorder is storing information (track start and end position) from
WRITING
TEMP OVER • Heat has built up in the recorder.
REC STOP
TITLE FULL • You tried to enter characters that exceeds the maximum number for a
• You tried to enter characters that exceeds the maximum number for a
TOC DATA • The recorder cannot read the disc information correctly.
ERROR
TRACK FULL • You tried to record more than 2,047 tracks on a disc in Hi-MD mode or
TRK FROM PC • You tried to combine or divide tracks that were transferred from the
NO EDIT
• You tried to combine or divide tracks that were recorded in Hi-MD mode
was storing disc information with the dedicated USB cable connecting
the recorder to a computer.
, Operation must be done only after pressing x and "SYSTEM FILE
WRITING" has disappeared from the display.
, Reinsert the disc.
, Place the recorder at a place with no vibrations and record again.
standard disc.
, Try recording again with another disc.
the memory to the disk.
, Wait until this process is completed. Do not expose the player to
physical shock, nor disrupt power supply.
, Let the recorder cool down.
title.
—For the European, North American and Australian models:
More than 200 characters to label a single track, group, or disc.
—For the Asian, African and tourist models:
More than 100 characters (in Hi-MD mode) or 200 characters (in MD
mode) to label a single track, group, or disc.
disc.
—For the European, North American and Australian models:
A total of more than approximately 55,000 characters (in Hi-MD
mode) or 1,700 characters (in MD mode) for titles in a disc.
—For the Asian, African and tourist models:
A total of more than approximately 27,000 characters (in Hi-MD
mode) or 1,700 characters (in MD mode) for titles in a disc.
, Insert another disc.
, If it is no problem to erase the entire disc, do so (page 61).
more than 254 tracks on a disc in MD mode.
, Erase unnecessary tracks (page 60).
computer.
, You cannot combine or divide transferred tracks.
using the MD Simple Burner software.
, You cannot combine or divide tracks recorded in Hi-MD mode with
the MD Simple Burner software.
91