Dispensing The Ingredients - HP IndiChrome User Manual

Dispensing the ingredients

Note For a first can, new first can, and additional cans, use the weights shown in Best Mix (g). For
a fix can, use the weights shown in +Fix (g).
Best Mix (g) and +Fix (g) lists
1
2
WARNING! Verify that the diaphragm is at the bottom (closed) end of the new empty receiving can by gently
pushing down on it with the rounded end of a spatula.
Note A fix bottle is sometimes used instead of an empty receiving can when preparing a fix can.
3
4
5
Dispensing unit
48 Chapter 4 General procedures
Verify that the appropriate nozzle is installed in the dispensing unit and that the
spacer ring is used if necessary. See "Adjusting the dispensing unit for the press" on
page 35 for details.
Before dispensing any ink, place an empty receiving can or fix bottle on the weighing
pan of the electronic scale in the dispensing unit.
Open the transparent safety door of the dispensing unit, and insert the first or next
ingredient can listed in the Ingredients list. Close the safety door.
Press the red Tare button on the scale's base to set the scale to zero. Do this each
time before dispensing ink from the different ingredient cans.
Dispense the quantity of ink specified in the weight fields (Best Mix (g) or +Fix (g))
for the ingredient can that you inserted in the dispensing unit.
Transparent
safety door
Weighing
pan
Tare button
Dispensing
unit
Coarse
button
Fine button
Electronic
scale
ENWW