General; Use; Charging The Battery; Inserting/Replacing The Pumice Attachment - Silvercrest SHN 3.7 B1 Operating Instructions Manual

General

Hard skin (calluses) can form where the skin is exposed to particular stress due
to rubbing and pressure .
If the hard skin becomes too thick, e .g . due to ill-fitting shoes or very dry skin, this
can lead to pain .
If necessary, clarify the cause of excessive callus formation with your doctor .

Use

Charging the battery

1) Connect the mains adapter t of the charger e to a power socket .
2) Place the callus remover on the charger e so that the two contact points 8
on the underside of the callus remover are aligned with the contact points of
the charger w . Ensure that the contact points 8/w are completely dry .
3) The green, flashing charge level LED 7 on top of the appliance indicates
that charging is in process . Once the appliance is fully charged, the green
charge level LED 7 on top of the appliance lights up green .
NOTE
► The appliance needs around 3 hours to fully charge the first time .
► When the appliance is fully charged, you can use it for approx . 2 hours .
► If the charge level of the integrated battery runs low during operation, the
charge level LED 7 flashes . Charge the battery as described .

Inserting/replacing the pumice attachment

NOTE
► To order new pumice attachments 3/0, please contact the service
department (see section "Service") . Please have the IAN number ready
(see operating manual cover) .
To remove a pumice attachment 3/0:
1) Press the release 4 downwards and, at the same time, pull the side of the
pumice attachment 3/0 next to the release 4 upwards .
2) You can then pull the pumice attachment 3/0 out of the drive shaft socket 9 .
SHN 3.7 B1
GB │ IE │ NI │ CY │ 9 ■