Connecting The Usb Nano Receiver - Silvercrest SFMT 2.4 A1 Operating Instructions And Safety Instructions

SilverCrest SFMT 2.4 A1
The wireless mouse has an automatic standby function. If you
do not use the wireless mouse for a certain time, it will power
off. Move the wireless mouse or press any mouse button to
power it back on (the driver software must be installed).
If you do not plan on using the wireless mouse for an extended
period, we recommend switching it off by sliding the On/Off
switch (8) to the "Off" position.

6.2 Connecting the USB nano receiver

1. If you still have your old mouse connected to the computer, shut down
your computer, disconnect the device from your PC and restart the
computer.
2. Switch the wireless mouse on by sliding the On/Off switch (8) to the
"On" position.
3. Plug the USB nano receiver into a free USB port on your powered-on
computer. This is stored in the wireless mouse battery compartment
(10).
The operating system detects the new hardware and automatically installs
the corresponding drivers. Depending on the operating system, one of the
following messages appears:
Under Windows
When connecting the receiver for the first time, the installation process
runs in background and no message is displayed.
®
For Windows 7
When connecting the receiver for the first time, the operating system
displays "Installing device driver software". Wait until the message "Your
devices are ready to use" appears. Your mouse has been successfully
installed and can now be used.
If the connection to the nano receiver is interrupted or if it is not
possible to establish a connection, remove the batteries from the
wireless mouse and re-insert them.
12 - English
®
8 and Windows
®
10