Troubleshooting - GE T2100-ST1 Service Manual

Troubleshooting

6
The T2100-ST Series Calibration
Software is design to assist in gathering information when
troubleshooting the T2100 ST1 and T2100-ST2 treadmill.
For information on how to connect the T2100-ST Series Calibration
Software and retrieve error codes, refer to "Calibration" starting on
page 161. A description of the Error Code Tab can be found on page
179.
When you receive an error code from the T2100-ST series treadmill,
use the flowcharts in this chapter to help you identify and resolve
the error. Descriptions of the error codes are provided in this
chapter.
There are two methods for using the flowcharts.
If you know the failure mode causing the issue, scan the flowchart
titles for that failure mode and review the corresponding flowchart.
If you are receiving an error code, locate the error code in the
"Troubleshooting Guidance Base on Error Code" table, below, and
then refer to the referenced flowchart(s).
If you still cannot identify or resolve the error, contact local GE
customer support representative.
2097937-002 Rev G
11 March 2019
T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V
6
75