About This Manual - GE Datex-Ohmeda S/5 Technical Reference Manual

About this manual

Intended audience
This Technical reference manual is meant for service representatives and technical personnel
who install, configure, maintain, administer, troubleshoot or repair Datex-Ohmeda S/5
Anesthesia and Critical Care Monitors.
Notes to the reader
As the monitor setup may vary, some functions described may not be available in the monitor
you are using.
•
The order code for the printed manual is M1162897. The manual includes Technical
Reference Manual Slots and every slot has an individual document number. M1137263 is
the document number of this first slot.
•
Part I gives the reader an overview of the S/5 Anesthesia Monitor and S/5 Critical Care
Monitor. It contains the information needed to install, interface and troubleshoot the
monitors. Instructions for functional check and planned maintenance are also included.
Read the manual through and make sure that you understand the procedures described
before the installation of the monitor. To avoid risks concerning safety or health, strictly
observe the warning indications. If you need any assistance concerning the installation,
please do not hesitate to contact your authorized distributor.
•
Part II contains detailed descriptions of each component of the S/5 AM, CCM Monitor,
such as frame unit, parameter modules Remote Controller and Device Interfacing
Solution. Service check for each product, service menus and all the spare parts
information for the Monitor is included.
For information of parameter modules, Remote Controller and Device Interfacing Solution refer
to the "S/5 E-Modules, Technical Reference Manual". Service check for each of these products
is included in these slots.
The manufacturer reserves the right to change product specifications without prior notice.
Although the information in this manual is believed to be accurate and reliable, the
manufacturer assumes no responsibility for its use.
Installation and service are allowed by authorized service personnel only.
GE Healthcare Finland Oy (GE) assumes no responsibility for the use or reliability of its software
in equipment that is not furnished by GE.
Related documentation
S/5 Modules
S/5 E-Modules, Technical Reference Manual
S/5 Anesthesia Monitor
For instructions for daily use including cleaning and daily maintenance, clinical aspects and
basic methods of measurement see:
S/5 Anesthesia Monitor, User's Guide
S/5 Anesthesia Monitor, User's Reference Manual
Document no. M1137263-04
1