Chapter 5 Programming; Section 1 Before You Start Programming; Section 2 How To Use This Manual - NEC Sl2100 Networking Manual

PROGRAMMING
The remainder of this chapter provides instructions for programming individual program blocks.
S 1 BEFORE YOU START PROGRAMMING
ECTION
This chapter provides you with detailed information about the NEC SL2100 program blocks that may
be required to connect the NEC SL2100 to a data network and to configure the VoIP function. The
configuration and programming examples, found in the earlier chapters, can be a useful reference
when programming the data.
S 2 HOW TO USE THIS MANUAL
ECTION
This section lists each program in numerical order. For example, Program 10-01 is at the beginning of
the section and Program 92-01 is at the end. The information on each program is subdivided into the
following headings :
Description describes what the program options control. The Default Settings for each program are
also included. When you first install the system, it uses the Default Setting for all programs. Along with
the Description are the Conditions which describe any limits or special considerations that may apply
to the program.
The program access level is just above the Description heading. You can only use the program if your
access level meets or exceeds the level the program requires. Refer to
Mode on page 5-2 for a list of the system access levels and passwords.
Feature Cross Reference provides you with a table of all the features affected by the program. You
will want to keep the referenced features in mind when you change a program. Customizing a feature
may have an effect on another feature that you did not intend.
Telephone Programming Instructions shows how to enter the program data into system memory.
For example :
1. Enter the programming mode.
2. 15-07-01
Networking Manual
1507-01 TEL200
KY01 =
Hybrid (4W) Multiline Terminal
15-07-01 TEL
KY01 = *01
-
IP Multiline Terminal
How to Enter Programming
*01
+
5
5-1