NEC Sl2100 Networking Manual page 175

ISSUE 1.0
3.5 Call Forward/ Off-Premise
Off-Premise Call Forwarding allows an extension user to forward their calls to an off-site location. This
feature works the same in a networked system as it does in a single system.
A call to an extension at a remote system will forward to the Abbreviated Dial bin using a trunk at the
remote system.
3.6 Call Forwarding with Follow Me
The extension user can program Call Forward Follow-Me to extension in a networked system. When
the extension with the Follow Me setting receives an incoming call, both the original extension and the
programmed destination extension starts ringing.
With a networked system, when Call Forward Follow-Me is enabled, there is a slight difference in the
telephone's display. With a single system, the destination extension displays the extension name for
the phone with Follow-Me enabled. With a networked system, the extension number is displayed.
3.7 Camp On
With Camp On, an extension user may call a busy extension and wait in line (Camp-On) without
hanging up. The call goes through when the busy extension becomes free. Camp On helps extension
users to get through as soon as a busy extension becomes free. It also lets callers wait in line for a
busy extension without being forgotten.
When you have set Camp-On you can choose to wait off hook or go on hook. If you go on hook your
phone will ring when the extension becomes free.
With a networked system, camping on to an idle extension and Trunk Queuing/Camp On for a trunk
port are not supported.
With a networked system, when Camp On is enabled, there is a slight difference in the telephone's
display. With a single system, the target extension's name is displayed on the phone which has
enabled Call Waiting. With a networked system, the extension number is displayed.
3.8 Caller ID Display
Caller ID information can be sent to the target extension in a networked system and show the Caller
ID on the phone's display. The ABB Name is also shown on LCD by searching ABB table at the target
system.
3.9 Central Office Calls, Placing: Seizing a Trunk in a Networked System
The system allows a user to seize a trunk in a networked system using the following methods:
Method of Outgoing
Specified Trunk Access (#9 + the trunk
number)
Specified Trunk Group Access (804 +
group number)
Trunk Route Access (9 )
ARS/F-Route
Networking Manual
Available
No
No
Yes
Yes
Note
See ARS/F-Route
SL2100
13-13